OneFlow Anti-Scale Systems (10 to 75 GPM)

OF744-10, OF844-12, OF948-16, OF1054-20 and OF1252-30 (Up to 30 GPM) OF1465-50TM and OF1665-75TM (50 and 75 GPM)

Flexible option for point-of-entry or point-of-use installation. Models are available for systems from 10 to 75 GPM. Tanks can be plumbed in parallel for achieving flow rates up to 1000 GPM.

  • Units come with pre-filled media
  • OneFlow media should be replaced every 3 years
  • 3/4″ to 1-1/4″ connection sizes (OF744-10, OF844-12, OF948-16, OF1054-20 and OF1252-30)

Replacement Media

Feed Water Chemistry Requirements

NOTICE

*Iron and Manganese – Just as with conventional water softening media, OneFlow® media needs to be protected from excess levels of certain metals that can easily coat the active surface, reducing its effectiveness over time. Public water supplies rarely, if ever, present a problem, but if the water supply is from a private well, confirm that the levels of iron (Fe) and manganese (Mn) are less than 0.3 mg/L and 0.05 mg/L, respectively.
Feed Water Chemistry Requirements pH 6.5 to 8.5 Hardness (maximum) 75 grains (1282 ppm CaCO3) Water Pressure 15psi to 100psi (103 kPa to 6S bar) Temperature 40°F to 100°F (5°C to 38°C) Chlorine < 2 ppm Iron (maximum) 03 mg/1* Manganese (maximum) 0.05 mg/1* Copper 1.3 ppm** Oil & H2S Must be removed prior to OneFlow® Silica (maximum) 20 ppm*** **
Copper Pursuant to the EPA drinking water standards, the copper concentration permitted is up to 13 ppm_ Typically originating from new copper plumbing, high levels of copper can foul OneFlow® media. For applications with copper concentrations greater than 1.3 ppm, please contact Watts Pure Water Technical Service at 1-800-224-1299. To further minimize any problem with excess copper, avoid applying excessive flux on the inner surfaces of the pipe and use a low-corrosivity water-soluble flux listed under the ASTM B813 standard. ***
Silica OneFlow® media does not reduce silica scaling. While silica tends to have a less significant effect on scale formation than other minerals, it can act as a binder that makes water spots and scale residue outside the plumbing system difficult to remove. This 20 ppm limitation is for aesthetic purposes.